Originally Posted by
OMD-227
Hi Tony,
We have had alot of the same problems. After the F1-08 issues were sorted out (staple unit phase deviation), we have had heaps of calls on varying folding positions & saddle unit jams.
There is a mylar deep down inside the middle of the finisher which needs to be replaced or refitted. Our service supervisor has done alot of them in the workshop, while a loan FN10 has been sent out. The whole finisher gets split into two halves to access it. Total pain in the ass.
I am sending you the service bulletins on inconsistant folding positions and all the FN10 improvements to your email.
Basically, we have had no further problems with these FN10's after the bulletins/mods are done. If you dont do them, they are the biggest piece of sh*t imaginable!
The FN10's have been our biggest problem for the last few months. Now they seem to be much better.
Bookmarks