drum indicator still blinking after replaced a new drum cartridge..
what should i do...
any sp mode to reset drum counter
& if yes how to enter sp mode..
ricoh technician
drum indicator still blinking after replaced a new drum cartridge..
what should i do...
any sp mode to reset drum counter
& if yes how to enter sp mode..
ricoh technician
to enter SP = Clear - Exposure - Clear - Exposure
Exposure is on the far left of the panel where you cycle between AE and Text/photo
type in 24 into the display - Start, type 7 into display and press start.
If that does not work open both doors. In the front door bottom right corner front frame side should be a little switch. Cheat the right hand door switch and then press the little micro switch down until the drum counter clears. The new drum should of had a little gear that hits that switch once but maybe it was out of position.
Im just going off memory here, been a long time since ive worked on one of these so i could be wrong
Evil will always triumph because good is dumb.
Its all shits and giggles until some body giggles and shits...
Been awhile myself, some of those sharps have a reset arm built in the drum unit. Pop the end cap off the drum and see if there is a cog and arm, reset if possible and put back into the machine, see if it resets.
thanx for d tips..
will try it and post result later
Bookmarks