E1-00 code on Sharp AR-168

**ebm** · 06-04-2007

Anyone have a fix for this code? Turning off/on does not reset.

**nightshade** · 06-05-2007

Being at home and not looking it up, my first thought is replacing mirror base "A" otherwise called the scanner assy.

But you could try reseating all the connections for the scanner especially the flat cable.

**cucuklotz** · 06-05-2007

HI,
Have you tried resetting by a crop 14 simulation?
Press Clear key, Interrupt key," 0 "key, Interrupt key,(display should go blank)Press "1" key ,press "4" key ,press start key.
Hope this helps, ANDY

**ebm** · 06-06-2007

Tried Sim 14 to reset, no joy. Also, tried to install firmware w/o success. Ended up replacing MCU PWB from another machine. Anyone, know the procedure to reprogram counts (total,pm,dv,drum)?

**just a tech** · 06-06-2007

this is from the ar-162,165,207 models ut will more than likely cross over to the ar-168 as well..they are in sim 24..

24 01 Jam total counter clear
02 Trouble memory clear
04 SPF counter clear *2
05 Duplex print counter clear *6
06 Paper feed counter clear
07 Drum counter clear
08 Copy counter clear
09 Printer counter clear
13 Scanner counter clear
14 SPF jam total counter clear *2

15 Scanner mode counter clear ..hope this helps. good luck

**nightshade** · 06-06-2007

By chance is it a AR-168D?

**ebm** · 06-06-2007

Yes, it is a AR168D. Sorry for the confusion. I do not need to reset the counts to zero. I need the procedure to program the counts from the old board to the new one.