Thanks:
0
Likes:
0
Dislikes:
0
-
Technician
- Rep Power
- 31
Sharp ar5320 error code e7
I have just installed a new power supply on Sharp ar 5320. I removed the laser unit because I wanted to blow out the dust. On restarting the machine it started showing this error code that was not before.
Can anyone please tell me what error code e7 - e7 plain means?
-
This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment from The Internet's largest collection of manuals
Paul@justmanuals.com
-
Service Manager
250+ Posts
- Rep Power
- 37
there will be a secondary code to accompany E7
E7-02 lsu trouble
E7-12 abnormal laser output
are the most likely if the laser has been replaced
-
I definitely agree with Bonnie. You'd have a laser trouble code (E7-02 or E7-16). Hold the start button down to confirm the sub code. If its a laser code listed above, double check your cables/harness for the LSU, if you removed it and now have the code. You may have missed a connection.
-
Technician
- Rep Power
- 31
You are right Bonie750 and am sorry for that Sir. The sub code is 10; E7-10. I have never encountered this code before - all the help is needed.
-
Technician
- Rep Power
- 31
Thank you wazza for correction and am grateful for that. The sub code is 10. I agree with you and bonnie750. Its a new problem to me. This problem has had me pissed.
-
Technician
- Rep Power
- 31
I have never had this trouble code before. The subcode is 10.
Read e7-10 ; Anyone with a clue please help. Bonnie750 and wazza are quite correct on correcting me. I had not known how to get to the subcode.
-
Service Manager
250+ Posts
- Rep Power
- 37
E7-10 is shading trouble (black correction)
it points to connection problems with the ccd or the mcu board.
my guess would be that the flat data cable to the ccd is not connected correctly/fully
-
Technician
- Rep Power
- 31
possibly yes and. I will give a try bro and post my findings. Thank you for responding while I try.
-
Very good chance you will need a new CCD unit mate.
If you check/reseat all cabling as Bonnie has stated, the copy lamp lights up OK, the firmware is up-to-date, the mirrors/optics are parallel and the code is still there, time for a new CCD unit.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks