So I have a Sharp MX-M550N with a ARF15 finisher attached. I send a job of 5 pages to be stapled on the top corner and it staples just fine. When I try to side staple in two positions, occasionally (about every other stack) the top 2-3 sheets that are waiting for the previous staple job to complete seem to come out faster and thus not aligned properly it then spits out the next 2 sheets and staples. Because of this, the stack is not aligned properly and the top of the two staples does not go through the first couple of pages. Now if I am doing multiples of this 5 page job, of course the first stack is good because the pages do not have to wait around to be stapled. I have cheated the door and inspected the inside during operation (mylars, rollers, alignment guides) and everything looks good. Is there a setting I can tweak or something I can look for to fix this. I did notice that the rollers on the exit side looked pretty smooth, but am not sure if this is a problem. Help!
Bookmarks