Thanks:
0
Likes:
0
Dislikes:
0
-
F1-10 Error on MX2700n
I have an mx2700 with the fnx1 finisher that goes into the f1-10 error as soon as the macine boots up.
The stapler unit and finisher control board have both been changed but that has not fixed the problem.
-
Senior Tech
100+ Posts
- Rep Power
- 38
Since you have replaced stapler and finsher control I would dbl check all harnesses and connections, after that, I think its the PCU next. Have you talked with Sharp about it?
-
check the harness from the finisher pwb to the stable unit, it might have stretched or kinked,
-
Check the wiring betven the PCB board and the stapler.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks