Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 34
AR-336 Error code e7-00
this machine has been beat on and not taken care of, intermittantly I get a E7-00 error, the rest of the time it does'nt appear to be scanning anything from the glass.
the light lights, and a page comes out but it's blank...interestingly prints from the print mode seem to come out.
this has a host of problems that will need to be taken care of if e7-00 is'nt a machine killer.
Last edited by LaserSharp; 10-04-2007 at 07:35 PM.
Reason: spelling
-
I've seen arching trouble with main charge cause this trouble code. Also, check the ground strap at rear of suction unit, customers have a tendency to turn lift lever 360 degrees and break ground strap. To prevent the lever from tuning 360, bend the flange at the rear of the suction tray outwards.
Good luck...
"You can't trust your eyes, if your mind is out of focus" --
-
Trusted Tech
50+ Posts
- Rep Power
- 34
Aha, I accually witnessed a handle turned around so the handle was pointing the wrong way, sounds like a ground strap maybe what I should look for, I just found a manual for this unit I'll try looking it up and see how to best access that.
Thanks
-
Technician
- Rep Power
- 35
Did you check the white reference sheet??? I noticed once I replace that the e7-00 goes away.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks