Thanks: 0
Likes: 0
Dislikes: 0
ARM316 problem
Hi to all I have problem with arm316. recently developer was replaced and unit performed for couple of weeks fine than it started to print images with white stripes. To be exact lines are parallel to longer paper edge (longer edge is coming out first) and they are always on same part of paper. different drum did not help. What is exactly happening is that on those spots image is totally missing. Any ideas?
i know this sounds silly.....but if the blank spots are in exactly the same place every single time....i'd suspect damp paper..put the same piece of paper through again...or paper from an unopened packet..
Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...
How far from lead edge is the blank area? Is the paper buckling?
Hi First line starts at 25mm from leading edge and it is approx. 10mm wide. Second one starts approx. 125mm from leading edge it is wide 10mm. There was slight difference on one copy but that could be attributed to late paper pick up from tray. Paper is not problem. It is stored in good conditions and there are 3 more units (arm207 and ar-5316) using same paper without problems. I don't have printouts from simulation (64-1) here, so i cant scan them. I might get them tomorrow.
Can attach sample to us?
Re: ARM316 problem
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
http://www.justmanuals.com
Paul@justmanuals.com
~96mm intervals? It sounds like a scratched drum, or poor drum ground to me. You've described it perfectly. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks