Not sure how this ended up in this thread, any how just take out the toner, developer unit and drum unit. Remove doc feeder if one. Remove cassettes. If after top tray roller and it has the rollors that are permanently attached remove bottom tray assy 4 screws. One at each corner. Disconnect wire harness that runs between machine and second cassette. Lift copier off cassette and stand on left end. Remove screw that holds second cassette drive gear and remove gear assy. Remove e-ring that locates bushing on feed shaft. Slide feed shaft towards clutch end drop down and remove Shaft. If newer style roller just pull out cassette and reach in and rotate roller half turn and unclip rollers and pull down.
Bookmarks