How to reset admin password on sharp mx-2310 ?

[DavePo]

Not sure how this ended up in this thread, any how just take out the toner, developer unit and drum unit. Remove doc feeder if one. Remove cassettes. If after top tray roller and it has the rollors that are permanently attached remove bottom tray assy 4 screws. One at each corner. Disconnect wire harness that runs between machine and second cassette. Lift copier off cassette and stand on left end. Remove screw that holds second cassette drive gear and remove gear assy. Remove e-ring that locates bushing on feed shaft. Slide feed shaft towards clutch end drop down and remove Shaft. If newer style roller just pull out cassette and reach in and rotate roller half turn and unclip rollers and pull down.

[TomK]

It is possible to reset the MX-2310. Send me an e-mail for the information.

[MRK23]

It is possible to reset the MX-2310. Send me an e-mail for the information.

MX2610 – MX3610 admin password resetprocedure

Turn off mfp
Flip Small micro switchesnear edge of MFP board next to serial port, move both of them up
MFP will then Auto Prompt sim24-30 when powered back on to ResetAdmin Password
Turn off mfp and set bothswitches back to original positions

[sharptech1]

this might help

[Chr15tophe]

this might help

Thats not the same password..

Your only changing the hidden service webpage password (service) not the system settings web page password (admin)...

nice try though, keep trying..

[ZOOTECH]

MX2610 – MX3610 admin password resetprocedure

Turn off mfp
Flip Small micro switchesnear edge of MFP board next to serial port, move both of them up
MFP will then Auto Prompt sim24-30 when powered back on to ResetAdmin Password
Turn off mfp and set bothswitches back to original positions

I have tried this and it works; if the switch to the rear is down and the other up, if memory serves me right, the machine will go into touch panel adjustment.
Not sure if the MX2310 has those switches.

[sharptech1]

The web page default password is Sharp with a capital S, right?

[Tom54]

Format the HDD(takes an hour to format).

[Akitu]

The web page default password is Sharp with a capital S, right?

With the old ARM boxes, yes. The new machines all use admin admin un/pw.

[SUPER LOU]

On the Main pub there are two very small switches. Turn on #1 then u can get to sim 24 to reset admin.