M-3501N lead edge adjustment

[KMtech69]

Hi alll,

I'm working on a MX-3501 n and the lead edge is way off with both copy and print and both single and duplex copy and print. I have tried to adjust it under simulation 50 but it doesn't change at all. any help would be great.
thank you

[rgcs1]

Try upgrading the machine to the latest Firmware first, i believe its Ver. 02.11.J0.a0.

then try adjusting Sim 50-1 again to see what happens.

[DAKOTADAN]

Hi alll,

I'm working on a MX-3501 n and the lead edge is way off with both copy and print and both single and duplex copy and print. I have tried to adjust it under simulation 50 but it doesn't change at all. any help would be great.
thank you

Are you doing the 50-28 sim on all the drawers, this helps
with reg. problems, Good Luck.