Thanks:
0
Likes:
0
Dislikes:
0
-
Technician
- Rep Power
- 34
AR 207 print question
I have a customer with a Sharp AR 207. They want to set the copier up to use the network print.
I have an old print board from some Sharp copier. I am not sure what model number of the copier. The board is an "andromeda GDI PWB Ver 1.0".
Can I use this board in the copier to run the printer?
If I can, then I can use the Pricom 3100 to connect to the network.
Is this possible?
Can I get the print driver for this off Sharp's web site. (I have the disk for the Sharp "AR M207", is this compatible?)
Thank you for your imput.
P 1</B>
-
Sorry, mlb.
Andromedas are AR-M237N, AR-M277N. I believe that this is the standard parallel port which must be removed to install the TCP/IP network card. It won't work on a Panther.
The driver is wrong too. The driver for a Pegasus (AR-M207) won't work on a Panther (AR-207). The mechanical parts are all the same, the electrical parts are all different.
For Parallel printing you need:
AR-PB8 Network Expansion Kit
AR-PA1 LCD Panel Kit
For Network printing you need:
AR-PB8 Network Expansion Kit
AR-PA1 LCD Panel Kit
AR-PS1 PS2 Expansion Kit
AR-NC3D Network Interface Card.
Good Luck finding all these boards. And if you do find them it will be cost prohibitive to follow through with.
=^..^=
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks