Hi guys,
I've had one of them typical Friday afternoon machines.
The original problem was a jam in the fuser with a burning smell. So i removed the jam and replaced the upper and lower heat rollers, aswell as the cleaner roller. Boot up was fine, warm up was fine, but when i went to copy, it started to pull the paper and then stopped. It showed no error until i opened the front door. In the side door, the paper was sitting just before the transfer belt.
Checking the codes showed "POD1_FUS". Service manual says "POD1 JAM ( Detection Of Twining To Fuser)".
I've pulled out the exit unit, pod 1 and 2 are fine, no issues there. I re-sat all relevant cables. Rebuilt the fuser and still the same code and same issue. Google brings up useless rubbish, so i was hoping one of you kind souls could help me here.
Thanks in advance for any suggestions.
Bookmarks