Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4
  1. #1
    Technician Andyyy41's Avatar
    Join Date
    Nov 2012
    Location
    Luton
    Posts
    14
    Rep Power
    12

    MX-2600 POD1_FUS

    Hi guys,

    I've had one of them typical Friday afternoon machines.

    The original problem was a jam in the fuser with a burning smell. So i removed the jam and replaced the upper and lower heat rollers, aswell as the cleaner roller. Boot up was fine, warm up was fine, but when i went to copy, it started to pull the paper and then stopped. It showed no error until i opened the front door. In the side door, the paper was sitting just before the transfer belt.

    Checking the codes showed "POD1_FUS". Service manual says "POD1 JAM ( Detection Of Twining To Fuser)".

    I've pulled out the exit unit, pod 1 and 2 are fine, no issues there. I re-sat all relevant cables. Rebuilt the fuser and still the same code and same issue. Google brings up useless rubbish, so i was hoping one of you kind souls could help me here.

    Thanks in advance for any suggestions.


  2. #2
    Master Of The Obvious 10,000+ Posts
    MX-2600 POD1_FUS

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    16,164
    Rep Power
    264

    Re: MX-2600 POD1_FUS

    After one of these jams check to see if there is any developed image on the primary transfer belt. If no, the primary transfer belt is probably not turning. Broken gear? Torn belt? Motor problem? =^..^=

    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.


    blackcat: Master Of The Obvious =^..^=

  3. #3
    Technician Andyyy41's Avatar
    Join Date
    Nov 2012
    Location
    Luton
    Posts
    14
    Rep Power
    12

    Re: MX-2600 POD1_FUS

    Thanks blackcat, but it was a dodgy thermostat on the fuser. Kept needing to be popped. No idea why it was giving the above error, replaced and working fine now though.

    Thanks again.


  4. #4
    Technician
    MX-2600 POD1_FUS

    jrtwilley's Avatar
    Join Date
    Nov 2014
    Posts
    12
    Rep Power
    8

    Re: MX-2600 POD1_FUS

    I'm trying to get this one solved myself. Mine's an MX-4141N, but the POD1_FUS jam is driving me nuts as well. One told me that it was thermistor(s). One reply I had was the wire harness on the frame side of the fuser connector.


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here