The dev is pullling out , i changed the drum assembly (whole unit+drum+Main charge),tranfert unit, problem persist, contacts on the left door seems clean as well as ground for drum.
Advice is welcome.
The dev is pullling out , i changed the drum assembly (whole unit+drum+Main charge),tranfert unit, problem persist, contacts on the left door seems clean as well as ground for drum.
Advice is welcome.
Try to check if the Developer is sticking on the drum if so, Check the bias of the DV or test other DV unit. If you have HV try to test it also.
Capture1.JPGCapture.JPG
Hope this will help if it is hard to remove?! No pain no gain...
It's not as hard as some of the newer series machines power supplies. But it's behind another board as the illustration shows.
Good luck.
Bil
Bookmarks