I have a mx 2600 that locks up turned off op panel off first then main switch inside door sometimes that will work other times it will start showing the SHARP NAME AND THEN JUST LOCKS UP. ANY IDEAS WOULD BE APPRECIATED Thanks
I have a mx 2600 that locks up turned off op panel off first then main switch inside door sometimes that will work other times it will start showing the SHARP NAME AND THEN JUST LOCKS UP. ANY IDEAS WOULD BE APPRECIATED Thanks
The HDD is a good starting point if firmware is up to date and AC power is clean and within specs. I've always done a HDD optimization from the admin mode as a preventive measure, along with a read/write test before replacing HDD; and a format other than system area after data saved. By connectors on MFP board, I'll assume you mean the memory and flash ROMS.
"You can't trust your eyes, if your mind is out of focus" --
replace the USB PWB in the keyboard
Replace USB converter board. Causes keyboard to lock up as well, if you can get your machine operational (my last machine with these symptoms booted up successfully 50% of the time), you'll notice the keyboard doesn't respond and all the lights will be on.
Cthulhu for president! Why settle for the lesser evil?
Bookmarks