MXM-700 POD1_N

**Ditchman** · 09-07-2014

Hi Guys

Hope someone can shed some light on this one.

Machine is jamming on double sided copying, second side is not entering fuser correctly and then bottom half of page follows around with secondary transfer belt and lodges in behind it. Jam Code is POD1_N.
Have tried new

Secondary Belt
Fusing Unit
Left Hand Door
Drum Unit
Exit Section
Firmware
Registration Unit

Still happening, im a bit lost at this stage and hope someone can help

Could i still have a problem with presssure adjustment on the new fuser?

Thanks

**blackcat4866** · 09-07-2014

When you say exit unit, do you mean delivery/turnover? That's what I would have gone for.

Have you tried different media? Does the paper curl? =^..^=

**Ditchman** · 09-07-2014

Yes exit section is delivery unit

Have also tried different paper, paper doesnt seem to curl, seems to "not enter the fuser" then bottom half follows around with secondary belt

Thanks for input

**blackcat4866** · 09-07-2014

I thought that sounded familiar:

Misfeeds (jam code POD1_N) intermittently. Occurs 18 times in 200K copies. The misfed piece of paper is frequently missed because it is behind the transfer belt, and discovered much later. Paper is diverted around the wrong side of the registration guide, and forced behind the transfer assembly. Mounting flange for the registration guide is too wide blocking vertical path. Grind down the mounting flange for the pre-registration guide until it is flush with the guide.

It's been a little while since I recorded this, but I have a recollection of finding rough spots on the registration guide, where the support brackets mount. =^..^=