If your 25-1 and 2 are good then have you checked your side door transfer/sep unit?
It was at about 110.
Yes, that's after a DV change.
Did you replace the Developer? if yes, after the calibration you said the value is 110 it is in range it must copy well after the DV replacement...Did the undertone comes after a couple of hundred or thousands of copies? if yes try to check the toner itself maybe it is not dropping a toner properly thou the clutch is rotating or try to test also a good DV unit...
I should have completed this thread a long time ago. The problem turned out to be the toner clutch.
NOW, I have another one with the same issue - undertoning. I'll change the developer and it will run just fine for 3 to 6 weeks. Then out of the blue, undertone.
I have tried a new toner clutch. I'm thinking a new drum/charger unit and a toner sensor?
It's throwing a F2-40 code as well.
I've had a couple throwing me that F2-40 code. It was worn out rear mag bearing...(replaced under waranty).
Th.
Bookmarks