Toshiba e-studio 310C print controller fiery crash

[mandd]

I have a problem, power reset while Fiery was doing something.
Fiery Boots, but then I get "Please Wait", firmware appars to be nuked
Current firmware/bios X3e+ Rev E
I can still connect to it with Colour Wise Pro,
however it ignores all print requests.
fiery controller GA-1120
I took the hard drive out, perhaps there is an image out there that I can write on it, and by doing that, magically fixing my Fiery?
There is also a recovery CD from EFI, I think...
any advice?
Thank you!

[iMind]

	Quote:			Originally Posted by mandd
	I have a problem, power reset while Fiery was doing something. Fiery Boots, but then I get "Please Wait", firmware appars to be nuked Current firmware/bios X3e+ Rev E I can still connect to it with Colour Wise Pro, however it ignores all print requests. fiery controller GA-1120 I took the hard drive out, perhaps there is an image out there that I can write on it, and by doing that, magically fixing my Fiery? There is also a recovery CD from EFI, I think... any advice? Thank you!

Hi, on ricohs, when the fiery displays "Please wait", you´ll have to install the fiery system, this system CD is like windows boots form CD and take more or less 40 minutes to install. sounds like bad news.

[mandd]

where can I find that CD?
I looked everywhere..