Thanks: 0
Likes: 0
Dislikes: 0
I have a Toshiba e-Studio 6530C with error CD81. Online describes it's waste toner auger locking up. I checked it and cleaned it looks fine. However when I start up the machine a grinding gear skipping noise is coming from the fuser unit as soon as it tries to print the paper stops in the fuser. Is CD81 a fuser problem or waste toner auger???
It's TRU waste toner locking which caused noise and give you error. It's behind 2nd BTR, you may need to vacc and clean toner in its pipe. Some worse case, you need to replace the motor too.Originally Posted by Alex1
Fuser drive gears have an issue in that model. And could be dropping bits on the waste toner augers. did you clean the correct waste toner drive? You should have cleanrd the one in the transfer/duplex door
Sent from my Nexus 5 using Tapatalk
CD81 is second transfer waste, not drum waste, not primary transfer waste, not developer waste. There are three augers that transport the second transfer waste to the bottle in the rear of the right door. You'll probably find a pinch of woolly fibers at the transition from the horizontal auger to the vertical auger. It doesn't take much to stop up the system. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Thanks for the info are these all leading to the waste toner box? What's the best way to get to the augers
As far as the grinding noise coming from the fuser, The 6530 is notorious for having the fuser drive gear (located in the copier) for getting stripped. It is real easy to replace. But I have also seen where the drive assembly needs rebuilt. I would go the easier route first. As far as the CD81 look real close at the gears driving the second transfer waste toner auger
Take the cover off of the right door. You'll see everything that you need to see. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Reply With Quote
Bookmarks