Toshiba e-Studio 3511 NIC reset

[Clif]

Hello

I have a 3511 in the field that drops off the network after a short time. i've checked for conflicts, network integrity, etc.

Does anyone know how to enter simulation mode for the printer module on a 3511 and the simulation nimber to reset or initialize the printer module.

Thanks

Clif

[talatm]

helloh


You have to reset your copier with following prosidure

press 0 and 8 semotancely and power on

test mode will disply

enter 669 press start

then touch initionalize on touch panel

it will take few seconds

power off then on

It's the way to reset your copier if you face any other problem in future you can mail me at my e-mail id & the id is talatsgg@yahoo.com
thank's
TALAT MASOOD
FROM PAKISTAN

[tsbservice]

It's NOT a good idea to do this code for NIC reset, instead of this you can try just 08/693 (Initialization of NIC information) returns the factory default of NIC card.
Good luck and let me know if you have any problems with this.

[mckinley]

don't use 08 669, unless you want to make your copier into a teapot.
as tsbservice says use 08 693, the thing i've found is that now 3511's are getting on, the NIC's are getting a bit ropey & sometimes require replacing.

[Clif]

thanks guys. yeah, i'd never initialize a copier unless I was planning to replace the main board.

clif