All ,grids and saw tooth's have been replaced and it did not change , I was able to run a calibration through the user mode for copy, 300dpi and 1200 dpi , it made black a little better but not the colors. I still can not make 05-2742, Other things that don't seem to work are the counter codes for resetting life counts in 08, and under user there is suppose to be a way of entering a user service mode but that's not there either. I think I have ruled out everything drum related , Still can not figure out how to release the drum potential sensor holder so it can pivot up. I have attached pics so if anyone can better direct by drawing an arrow that would be great !
I was able to print a page using S9 mode and the developer counts for each of the consumables is no more than 67K , of course that could just mean that counters were reset but parts not changed . The unit has 1,8 mill plus on it.
I can also be fighting bad DV but the DV brushes look OK or after market toner .
I have the C6560 manual , hard to believe the codes and way of doing things are that much different ,
Last do you know what the default admin code is ?
potenial sensor.jpgpotential sensor holder 1.jpgpotential sensor holder 2.jpg
Bookmarks