Toshiba E Studio 230

[craigo]

This copier only jams after machine is turned on in the morning or sometimes when it comes out of a prolong sleep.
When misfeed occurs it's in the fuser and mostly accordianed. Fuser claws are good as well as the springs. I have replaced the upper and lower fuser rollers. I'm mainly a Ricoh guy and stumped. Any help would be appreciated.

Craig

[Vincent128]

Machine jams after setting for a while issues are generally sticky drive sections/gooped up oilite bushings/clutches.

I'd pull the drive section out and inspect/clean/lube, check drive pins on drum shaft, replace high low clutches and pull all the regis/transport rollers out.

[copyguy69]

I would try replacing the claws anyway and check what the temp. settings are set at in power saving mode. Good luck

copyguy69