Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 15
Toshiba C6550 / duplex exit section questions
I have one with 800+ K skewing pages as it exits the bridge unit and before the duplex section because there is a section between the two that has a set of rollers and the bottom rollers are obliterated by heat.
I am having trouble identifying that section in the parts manual as well as finding in the SM how to remove that section or get to those rollers.
I believe it is ADU-MID and the roller is #21 6LH8004000, 20181005_131647.jpgit is the roller under the gray roller pictured here.
Can these be removed from the inside if I pull the duplex unit out ?
Thank You in Advance for your assistance
-
Re: Toshiba C6550 / duplex exit section questions
If that is the unit I think it is take the fuser unit out, then the door switch cover at the front and then unplug the assembly,, then its just 2 screws and it slides out, I find it's some times easier to put it back in by removing the lower plastic cover above it. I keep a few if those black rollers in the car now as it's quite a common fault
Sent from my F8331 using Tapatalk
-
Trusted Tech
50+ Posts
- Rep Power
- 15
Re: Toshiba C6550 / duplex exit section questions
Thank You Clint , what you are describing sounds like the correct location. Do I have the correct part # ?
-
Re: Toshiba C6550 / duplex exit section questions
That part has been updated. The new part number is 6LH18004100 RLR-PINCH-14_NW. Those rollers are now white. Also you should take a good look at the guide the rollers mount to as it can warp from the heat also. I usually replace both. That part # is 6LJ07910000 Guide-exit-m.
-
Trusted Tech
50+ Posts
- Rep Power
- 15
Re: Toshiba C6550 / duplex exit section questions
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks