Thanks: 
Likes: Hi everyone! I have error c010 to toshiba e studio 452! I was trying almost everything, replace main motor, check all gears, check developer unit, drum unit and fuser, everything its ok.
Dislikes: 0
Hi everyone! I have error c010 to toshiba e studio 452! I was trying almost everything, replace main motor, check all gears, check developer unit, drum unit and fuser, everything its ok.
There si NO connection between feed clutch and main motor (C010 error - Main motor abnormality: The main motor is not rotating normally), right?
I've see C010 on three occasions:
Main drive pack is hard to turn, especially developer drive gears and clutch. Clean and lubricate main drive pack.
Drive components all turn freely. Failed main drive motor. Replace main drive motor (6LA62281000).
Six accordian jams in the fuser (not removed) stalls the main motor drive. Worn heat roller, broken fuser claws, and worn exit roller exacerbates problem. Rebuild fuser unit (6LE82806000), and exit roller (6LA65821000).
Why are you wasting your time? You know that most parts are no longer available? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Which clutch? What about LGC board? I was replaced main motor, check the fuser, dev unit and gears...
Last edited by Nikola Karamanov; 01-27-2019 at 10:34 AM.
There are many clutches in the feeding components...
I change the drawer and for now problem is gone. I think is LGC board..........
Last edited by Nikola Karamanov; 01-28-2019 at 10:38 AM.
This has always been the Developer Drive motor for me.. the problem is likely too much drag on the system, but for lack of time pulling everything apart, I've always just replaced the motor. The cause is likely that it's too much drag coming from the lousy Developer Units locking up, at least that's my opinion.
OC
Drum drive shaft rubber cross thingie that breaks after replacing the drum and blade and not using patting powder on the drum
Sent from my ONEPLUS A6000 using Tapatalk
OK before you go blasting Clint.. YES! " thingie " is a valid Technical Term!Originally Posted by clint@clintsimonsen.com
I have changed main motor and i have check the drum unit, its rotate smoothly and gears its OK. Three days working from upper drawer without error c010. I dont know...
Reply With Quote
Bookmarks