Estudio 3511 network issue

[khouston53]

The screen will not stop indicating the "network initializing" message. If I plug it into the network it does not obtain an IP and continues to display the above message and when I plug nothing into it at all it does the same. I try to get into the network config under the admin section and the Button is grayed out not allowing me to access the setting so that i can assign a static IP. I have tried reseting the NIC card and I have set the machine back to factory default... Any suggestions? I have a spare NIC card and was going to try and swap it out, but the light on the current nic card lights as it should......

[TheOwl]

Before replacing the NIC, try the following.

08-693 (Reset the NIC)
08-1119 (Reset the NIC)

If those don't get your card up and running, then there is a jumper setting on the card it self. Remove the card, and change jumper settings for OP2 or FACT then plug the card back in and turn the machine on. When the lights on the card flash between Green and Orange, turn the machine off and then replace the jumper back to the original setting.

Failing that, do a firmware upgrade on the machine (including the NIC) and failing that, format the HDD using 08-690 mode 2.

WARNING -08-690 mode 2 will cause the loss of any information contained on the HDD including the address book, deparment codes, e-filing and etc.

If all this doesn't work, then replace the NIC and make sure it's firmware is concurrent with what is on the machine.

[Baphomet]

TheOwl has given some good advice. I have had to replace quite a few NIC's on the eBridgeI machines. I just want to point out one thing which might save some frustration if you replace the NIC. It will be ruined if the firmware you install is at an older version than what is already on the NIC. Perhaps the following quote from Toshiba's TechNet will clairify what I mean:

	Quote:
	To avoid corrupting the NIC board on these models, do not rewrite (downgrade) the NIC firmware to a version older than the following. 230/280 2.01B 350/450 2.02D 3511/4511 2.02D If the firmware is downgraded to older versions, the board will be damaged and have to be replaced.

It should be pointed out that if you updating via the USB thumbdrive, version 200 is the version with 2.02D NIC firmware on it so any version at or after 200 will be safe.

When I am in front of an eBridgeI machine which is stuck on "network initializing" I will try and update the firmware to the latest version and if it fails at the NIC part then I know the board has been corrupted and I relplace it.

[atudorica]

reset the NIC from control panel only
worked for me every time
08-693
do it up to 20 times
when "initialize" button apears on screen it is done