F030 eS600

[jawir]

Dear all Pro,

I need your help, I'm facing problem from eStudio 600. the problem is F030. I try to upgarde the firmware become 329 by using USB storage device. but when falsh update LSR firmware is always fail. I try to update one by one. and in LSR, PFC, and Main engine firmeware is always fail. I try to update using JIG (PWA-DLM 350 48 MB) but still failed. Finally I change the SYS LGC and Main LGC including both NVRAM. Still cannot fix the problem F030 occured. when I try to entering 08 mode to check the firmware, "MACHINE INFORMATION ERROR, LONG PRESS ENERGY SAVER" appear. I have checked the cable, from SYS and LGC, also from PSU to SYS or LGC. everything is good (I checked using Multi tester).
Does any one having similiar this problem before, please if there is any advice or idea I really apreciate it.

thank you and regards

[ivovb]

Are you sure about the code? I can not find it in SH.

[Sbarro]

[E030] Power-ON jam
[3F00] [3F10] [3F20] [3F30] [3F40] File I/O error

[jawir]

Hi All,

Sorry for this confusing information from me, after i checked again the code is F070 (communication error between sys CPU and engine CPU).

again I'm sorry and thank you for your attention.

regards

Jawir

[ivovb]

Did you follow procedure for changing Sys board as described in SH? Also I would suggest to change one board at a time - firstly Sys.

BR

[MUMMIM]

hi jawir !

you can try codes 08-693: 08-947 and you update again.

good luck to you

Hi All,

Sorry for this confusing information from me, after i checked again the code is F070 (communication error between sys CPU and engine CPU).

again I'm sorry and thank you for your attention.

regards

Jawir

[jawir]

Hi Every body,

Ok I will try as your direction. I will update situation soon. And by the way I have follow the instruction as in SHB. Even Now I put back all old LGC and SYS board. Because there is no effect even I replace with the new one.

Regards