E-166 C44 error code

[k1ks]

Good Morning..

Can somebody help me with this C44 error? I already replaced the fuser assy, reset the 08-400 code.. but still c44 code appear.. .. Thus the power supply caused this error?

[Harry]

check if fuserlamp lit if not check for triac short or open of powersupply
change powersupply if you have one
good morning at all

[k1ks]

Yes! Fuser lamp goes on (lit) after a few seconds it turns off and then C44 code appear..

[Harry]

You says to change fuser assy maybe there are bad thermistor on it check also distance to fuser roller.Bad Pins on the Side Connector.There no Probleme on the Powersupply i think its more a thermistor o harness problem
Good Luck

[mitsubee]

Use 08-400-Key in 0-Start... try this before confirming the themistor.....