| Some precautions to be aware of is to make sure you have the right firmware, and if the firmware fails, you may need to get the actual JIG which I beleive Toshiba still rents, but quite pricey.
You may also have to verify network settings obviously in the admin section of the control panel.
After Firmware you may need to do the following.
Perform 08-693 (initialization of the NIC information).
and 08-690 to format the HD
If you do not have the service manual then follow these instructions at your own risk.
To Upgrade or Add Firmware to a New HD
Update of HDD program data and UI data.
• Create partitions. (In case of using the download jig, this is not necessary.) While pressing [3] and [CLEAR] button, turn the power ON. When “Firmware Version Up Mode” appears on the LCD, key in [3] and press the [START] button.
Turn OFF the power of equipment.
(1) Download the firmware you need (I don't have a copy of any of it.)
(2) Put in on a USB drive formatted as FAT
(3) Take off the cover plate that covers the USB slots.
(4) Connect the USB storage device to the USB connector (host) on the SYS board.
• Do not connect multiple USB storage devices together.
• The USB storage device can be connected to either of 2 USB connectors (host).
• In case the printer kit (GM-1010), printer/scanner kit (GM-2010) and scanner upgrade kit
(GM- 3010) are used, the update must be performed after all the "dongles" are disconnected
from the USB connector (host) and only the USB storage device is connected.
Nothing can be in any of the USB slots besides the firware USB key.
(5) Turn ON the power while [4] button and [9] button are pressed simultaneously. The screen for selecting the items to be updated is displayed after 3 minutes. “*” is displayed next to the items to be updated. (All items other than "0. OS Update" are selected in the default settings.)
(6) Select the item with the digital keys. “*” is displayed next to the selected item. Display or delete the “*” by pressing the number of the item. All items are selected in the default settings.
• Select all items to update the firmware of the equipment in a batch.
(7)Press the [START] button.
Updating starts and the processing status is displayed on the LCD screen. When the multiple items are selected, updating starts in order of item number.
(8) “Update Completed.” is displayed at the bottom of the LCD screen after the updating is completed
properly.
(9) Turn OFF the power, remove the USB storage device and install the connector cover.
(10) Perform the initialization of the updating data (NVRAM updating).
a. Turn ON the power while [0] button and [8] button are pressed simultaneously.
b. Key in “947”, and then press the [START] button.
c. Press the [INITIALIZE] button.
d. Reboot copier
Last edited by blaineV; 05-15-2009 at 04:52 AM..
Reason: Added a few more things
| 
Linear Mode
