Toshiba e-studio 352 developer setup?

How can i set developer at this machine?

copies are ligt and worn.

any auto developer adjustment is avalaible?

how can i do it?

Best Regards.

HAYDAR64

[Harry]

shut down copier, hold 0 5 keys power up copier with keys hold adjust appairs in the display digit 200 then start after a 3 or 4 minits display change to ajust mode if the range is 240 everithing is ok set and turn of the copier.hope that help

[blaineV]

I assume you cleaned and checked charge/trans/sep wires make sure they are clean...

Yes, i was cleaned all wires and rollers. Developer and toner is changed but copy is not good.

[Peter Sim]

	Quote:			Originally Posted by Harry
	shut down copier, hold 0 5 keys power up copier with keys hold adjust appairs in the display digit 200 then start after a 3 or 4 minits display change to ajust mode if the range is 240 everithing is ok set and turn of the copier.hope that help

Hai, is this machine are same adjustment with the e-studio450?Need to wait for 3 to 4 minutes to complete the developer adjust? I dont have the adjustmet code for e-studio450 machine.

[ivovb]

Yes Peter,
they are the same concerning developer adjustment.

BR

[Harry]

You have to print out a List At Machine of Reboot with 04 111 e set.
If quality is good check The optiks dirty optiks make fade and clear copys.
Good luck

[blaineV]

Take the glass off and clean bulb mirrors and underside of glass, also clean glass of laser unit.