E010 In Toshiba 350

[nasrullahbutt]

hi every one plase tell me E010 Code in Toshiba 350
wating for your kind responce
nasrullah butt

[mdanaj]

Paper transport jam

[E010] Leading edge of paper not reaching the exit sensor

Open the jam access cover. Is there any paper on the transport path?
|

��

YES

�� Remove the paper.
NO
Is the exit sensor working? (Perform the input check in the test mode: 03-[FAX]ON/[2]/[B])
|||||||||��

NO

�� 1) Check if the connector of the exit sensor is disconnected.
2) Check if the connector CN302 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the exit sensor.
6) Replace the LGC board.
YES
Is the registration clutch working? (Perform the output check in the test mode: 03-108/158)
|||||||||��

NO

�� 1) Check if the connector of the registration clutch is disconnected.
2) Check if the connector CN318 on the LGC board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the registration clutch.
6) Replace the LGC board.
YES

Check the registration roller. Replace it if it is worn out.

[BoBa]

replace exit sensor

[mitsubee]

When you ON the machine it straight away e010 or u copy half way till the fuser part then e030? if straight away pop up happened then the exit sensor lever is broken..is not then the exit sensor is faulty or dirty.