e-studio 45 not boot!

[laktech]

Last i was using it and power of. the next day power on the screen only display image of it and halt there.

if i plug in cable data of hardisk , the HDD not rotate but plug out, it rotate. I was replace cable but not result.

Can you help me?
Thank!

[ivovb]

Put new HDD in the machine and format it.

BR

[aalex_bom]

	Quote:			Originally Posted by ivovb
	Put new HDD in the machine and format it. BR

YOU MUST set Master for HDD,
log in 08 - 690 - 2 - set

[laktech]

yes, i was replace new HDD from another toshiba ,set master, and format HDD but not ok.
Note, if i plug in cable data of hardisk , the disk not rotate but plug out, it rotate.
Not enter SP mode.

[ivovb]

Try cable select of HDD.
Replace interface cable of HDD.
Replace Sys board.

BR

[laktech]

Thank,i's replaced sys board ,it ok.But how is old sys board, not solution another, not repair it?
And more, i want to know reson which sys board do this state.

[emujo]

Probably because it is an E45 which is at least 10 years old. Things besides UFRs are going to break on these older systems. After you replaced the system bd, did you look in 08/253 to see if you had any "F" codes? If your going to keep it you might want to invest in the jigs, and EEPROMs to get the firmware up to date...especially if you use it as a printer. Oh, by the way, not getting past the splash screen "copier logo" is usually an indication of bad memory. EMujo

[tech07]

I've fixed quite a few display problems on this model by replacing the power supply pcb