help for install e-studio45 printer with lan port

[amirshkh]

help for install and use lan port for e-studio45 as printer
i use lpt port for printing (speed is low) and i cant use a long wire
can i use lan port for printer ?
if i can tell me how?
thank

[ivovb]

Go to printer properties of already installed driver.
Open Ports Tab.
Press Add Port.
Choose Standart TCP/IP Port - Next.
In upper field input IP address of printer. Don't touch lower field. - Next
Check Custom. Don't touch Settings. - Next - Finish.
Apply settings in Ports Tab.

BR

[amirshkh]

	Quote:			Originally Posted by ivovb
	Go to printer properties of already installed driver. Open Ports Tab. Press Add Port. Choose Standart TCP/IP Port - Next. In upper field input IP address of printer. Don't touch lower field. - Next Check Custom. Don't touch Settings. - Next - Finish. Apply settings in Ports Tab. BR

thank you
but how can i get ip of copier
lan port connect to hub swich

[amirshkh]

i get ip but still not working
when i input ip in explorer printer bord site is open in administor a can get seting list or job log and ... but in counter page when i hit the print boton
show me error and when i want to print file the file is not upload
tell me how can i fix this errors
thank you

[emujo]

I'm a little confused about what you're asking. Do you want to print via the parallel port, or the ethernet connection? If you're using the parallel port I believe you need the GUI driveri. (might be confusing the E25 with this model) Get someone to help translate your question into something we can read. Emujo

[amirshkh]

ok
its all abut ethernet port

[ivovb]

As I understand you have GA-1040. You have IP address setted in GA. Driver installed and working via LPT port but not via Network port. Web interface is working (You might have ping, too). So you don't have hardware problem in GA. You miss some setting(s). Check all settings in admin mode if you miss to input something - IP address, mask...

BR

[D_L_P]

You can print with LPT, you can get the web interface open over LAN.
That eliminates a lot of things right there.
Turn off your firewall and try printing. You may need to add an exception for printing with your firewall.

You say "its all abut ethernet port". When you added the port for the print driver did it ask you to pick which network card and whether to use LPR or RAW? If it didn't ask you to select any settings then it autodetected port settings and your port should be fine. If it did ask then delete the IP port, disable firewall and add IP port again. Make sure LPR is enabled in the web interface.

[aalex_bom]

i think that you can find in Operater Manual GA1040