about e-studio 35 GL-1010 PCI DRIVERS

[westfox]

Old hd BAD!
New hd's system is windows xp. Now I haven't the PCI Bridge board's drivers for windows xp. Now gl-1010 isn't used.
Where are download the pci bridge board's drivers?
Thanks!

[mckinley]

Toshiba - Photocopiers, printers and fax
if it's the GA1040 that is.
don't forget to check the version of the firmware on the NIC , you need v1.3 or v1.4 for xp to properly work or you may get probs, it should tell you on the config page what level it's on.

[westfox]

There is a matter mutually begging: my E-STUDIO 35 is what the computer and duplicator integrate together, the original operate system is the WIN NT, printing the plank as GL-1010.
Now the hard drive of the computer is bad, the system has already collapse, because of have no backup, also didn't recover the CD, I lately buy a hard drive now, the operate system that pack is the WINDOWS XP, the operate system can normally install with the start.
But hint"the PCI bridge connects the equipments" and did not install in the system equipments management, can't drive the duplicator, my estimate of did not install the Bridge board to drive.

I downloaded the GL-1010 to print to drive and the instauration CD of the GL-1020, but did not find out the Bridge board to drive.

Excuse me, does the everyone think the all new gearing this set duplicator, can use the WINDOWS XP?
How find out the Bridge board to drive the procedure?If can't install the WINDOWS XP, which the WIN NT that can provide the original machine kit?

Thank the everyone!

[m_tarighi]

excuse me sir i am a technician of toshiba in iran and i am looking for firmware of toshiba GL1010 .
can you help me in this case and send me a copy of firmware of GL1010 to my email address
my email address is : topriso@hotmail.com
i will be thanks a lot of you if you help me in this problem.