do your fuser unit heat rollers even try to get even a little warm? or are they cold ?
Checked the lamp and it appears to be good. (I said I didn't know how because I hadn't seen where it was and how to get to it, all is good there) so please keep the ideas coming knowing that I do know a little something about electricity.
I still only hear a motor running when the door is closed and the fuser is not getting warm. I figure it wouldn't get warm if it thinks the door is open?
Any other ideas?
Mai check Tehrmostates in Fusing unit they are in line with Fuserlamp misure the lamp one the connector if the circuit is open mayby its a thermostat ore thermofuse problem.
Harry
Check your T fuse.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Ok
The Dp 6510 is an e studio 650 with a coil in the fuserunit . if the thermostat is open c47 comes up .thank you fore advise mr rodgers but every body wrote of fuserlamp and triac and i confused with older toshiba analog copier who had this kind of problem so i cancel mi previos post right now
My unit is not giving any codes. Just the close front door message. I checked the t-fuse and it seems to check out ok.
I'm going to find a tech in the area who can come check it out. I guess this one isn't as easy as a fuse or stuck piece of paper.
I'll post an update if I fond out what the issue was for those who might come across this in the future or are curious about the solution.
There is another cover over the power supply that must be removed to see the rest of the fuses. They will be at the top left about 3 inches from the left edge.
Bookmarks