E-Studio 230 wierd prob.

[Oystercopy]

The most common sensor on that entire series is what I call the "Bypass" sensor. This is the one underneath the bypass tray. Remove the Duplexer and Bypass, flip it over and you'll see it. The common symptom prior to these just GOING OUT is that the customer will tell you that the machine "runs on and on" for several minutes after a copy job, then finally throws a jam. At first glance, this would look like it was adding toner, but not the case.
OC

[vstar]

Thank you, Oystercopy, could please give me the part number for these sensors? Maybe my supplier could get them for me then.

Thank you

Cameron

[ToshibaTech]

Sorry to leave you hanging before. Hard to talk myself into doing work when not at work.
Sensor under the bypass: 6LE09239000
It's called transport sensor 2 i think and is the same as the ADU sensors (two of them... which rarely go out compared to this location.)
You can also just stand on your head or if the floor is clean lay down and get to it. Just pop off the transport door, remove the black cover with two screws, you'll see it.

[vstar]

Thanks, Toshibatech. I will see if my supplier can get one for me.

Thank you

Cameron