Toshiba 3510 ce40

[CopyDawg]

Hi- Does anyone have a copy of the instruction page for CE40 on the toshiba estudio 3510 that they might be willing to email me? I have a copy of the manual saved to one of my computers and that computer has crashed on me! I loaned my hardcopy to a friend who is a technician and I can't get in touch with him at the moment and I am desperate! Any help would be appreciated! I just cant remember the exact operation to clear it.

Thanks!

[bauer]

[CE40] Image quality control test pattern abnormality
(1)Use "Image quality control abnormal detection counter Y to K display/0 clearing (08-573 to 576)"
to check the abnormal occurring condition for each color.
(2)Check “Output value display of image quality sensor / Low-density pattern (05-391-0 to 3)” to
check if the low-density pattern abnormality occurs for each color. The values under 180 for Y, M
and C, and under 20 for K are defined as low-density pattern abnormality.
(3)Check “Output value display of image quality sensor / High-density pattern (05-390-0 to 3)” to
check if the high-density pattern abnormality occurs for each color and identify the color which
pattern is abnormal. If the value is 628 or above, it is defined as high-density pattern abnormality.
(4)Set the values of “Image quality closed-loop control / Contrast voltage (08-556)” and “Image
quality closed-loop control / Laser power (08-557)” to “0” (Invalid).
(5)Perform “Enforced performing of image quality open-loop control (05-394)”.
È
180 or above (Y, M and C)
20 or above (K)
È
Under 180 (Y, M and C)
Under 20 (K)
Low-density pattern abnormality
Check the transfer belt. If the cleaning is poor, check the
installation status of the transfer belt cleaner unit and cor-
rect it if necessary.
È
To (9)
(If you have already performed this checking cycle once,
proceed to step (4).)
È
Under 628 (Y, M, C and K)|
È
628 or above (Y, M, C and K)
High-density pattern abnormality
•Check if the laser shutter is working properly.
<Procedure>
1)Take off the developer unit so that the laser shutter
can be easily seen.
*Clean around the laser shutter if the developer has
been spilled over.
2)While pressing the digital keys [0] and [3] simulta-
neously, turn the power ON.
3)Key in “417”.
4)Press the [START] button repeatedly to open and
close the shutter alternatively.
-If the laser shutter does not open/close, check
the shutter and correct it if necessary.
•Check if the developer unit has been installed properly.
1)Visually check the installation status of the developer
unit, and correct it if there is any abnormality.
|
È
To (9)
(If you have already performed this checking cycle once,
proceed to step (4).)

[ToshibaTech]

Easiest way to trouble shoot this error:

08 mode:
set 556, 557, 4546 to a 0

restart copier

make mono-color copies CMYK

see which color(s) look like crap

correct problems on that unit

reset 556,557 to a 1, reset 4546 to 5.