Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 6 of 6

Thread: CC90

  1. #1
    field Supervisor 50+ Posts mhmsaqer's Avatar
    Join Date
    Jun 2007
    Location
    Amman
    Posts
    83
    Rep Power
    35

    CC90

    this time three finishers MJ-1022 out from the packing and the three is failed on three different machines 282,232,352.
    the error is CC90 and the exact reason "using the test mode" is the upper tray is failed to move up ,moving down is fine.
    lower tray is working both upward and downward.
    what might prevent the upper tray from going up,since there is no signal from the board to the upper motor during lifting up in the test mode.
    i've tried to ballance the trays,rails are clean and smooth.
    any ideas men?
    thanks in advance.
    -----------------------------
    Be happy for a moment - this moment is your life.
    Omar Khayyam
    -----------------------------

  2. #2
    Vulcan Inventor of Death 1,000+ Posts Mr Spock's Avatar
    Join Date
    Aug 2006
    Location
    tampa,fl
    Posts
    2,067
    Rep Power
    63
    Check tcn I sent a pm to you.
    And Star Trek was just a tv show...yeah right!

  3. #3
    Trusted Tech 50+ Posts AVux07's Avatar
    Join Date
    Oct 2007
    Posts
    57
    Rep Power
    34
    Have you ever found a CC90 solution, I'm going back weekly for phantom codes.

  4. #4
    Trusted Tech 50+ Posts
    Join Date
    Oct 2007
    Location
    burnaby
    Posts
    79
    Rep Power
    34

    CC90 fix

    try bending bracket - see file
    Attached Images Attached Images

  5. #5
    Service Technician patwilf's Avatar
    Join Date
    Nov 2009
    Location
    Elkins, WV
    Posts
    41
    Rep Power
    30

    Bending bracket

    I have a mj1022 that is not lifting or lowering the upper tray. U can see that the bend in the tray. But do you still have the document for that? If so can you email it to me? patwilfong1983@yahoo.com

  6. #6
    Field Tech 500+ Posts
    CC90

    michaelc's Avatar
    Join Date
    Mar 2011
    Location
    England
    Posts
    590
    Rep Power
    37

    Re: CC90

    If the top tray is not moving correctly i would advise changing the rail/frame with the gears on. They are on each side of the tray. If it is a case where they have been bashed etc and the tray looks unlevel you can strip it down (same procedure as replacing the frame on each side of the tray) and level the tray back up. Its a bit of a pain in the as job and a little fiddly.
    It didn't say that I couldn't do it in the manual.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here