Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 2 of 2
  1. #1
    Field Supervisor 500+ Posts tcypy1961's Avatar
    Join Date
    Feb 2009
    Location
    Pensacola, FL
    Posts
    771
    Rep Power
    38

    toshiba e studio 350

    I changed the developer, drum, drum cleaning blade and corona wires. 2-questions.
    #1 i ran the procedure for new developer is there one for new drum???
    #2 what would cause off-setting after about 3 copies??? only notice it at the last 1/4 of page on one side of copy; i believe side closest to front of copier(11x8.5 direction). remember new drum and cleaning blade installed. can not tell you if it was doing this before i serviced copier.
    thanks!!!

  2. #2
    Vulcan Inventor of Death 1,000+ Posts Mr Spock's Avatar
    Join Date
    Aug 2006
    Location
    tampa,fl
    Posts
    2,067
    Rep Power
    63
    Developer setup does the drum and dev setup on this model. Did you reset the counters in pm support mode? Did you use setting powder on the drum? if not then the blade may have flipped. Also check the fuser roller for buildup.
    And Star Trek was just a tv show...yeah right!

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here