Thanks:
0
Likes:
0
Dislikes:
0
-
Tosh 2500-c getting EO11 codes.
The book says this code is caused from paper clinging to the transfer belt. It does this from all drawers about once in twentyfive copies. When I open the side registration door to clear the jam the paper is behind the transfer roller. Cant figure out what is causing the paper to go behind transfer roller. If anyone has any help or suggestions I would appreciate it. Thanks
-
Senior Tech
100+ Posts
- Rep Power
- 34
Got one here in the shop for a refurb doing the same thing but only seems to do it while duplexing...cleaned the separation comb then swapped the door assy and then transferbelt assy from the shop mule didnt change anything so I dont have the answer yet I only get to work at it when its quite...let us know if you find anything before I do!
-
Mine also mainly does it when duplexing too. Someone told me to bend the separation comb guide, also has the clinging sensor in it, bend it as close to the transfer roller as you can get. I did that and now the machine has been working. At least have not heard from cust in 4 days. I was not able to bend it much, did not think it was going to do anything but it seemed to work.
-
Senior Tech
100+ Posts
- Rep Power
- 34
Thanks I will try that...it seems like its a static cling type issue reminds me of the old Canon analogs with a bad sep corona.....
-
Senior Tech
100+ Posts
- Rep Power
- 34
I forgot to ask you did you just bend the comb itself or did you try to reshape the steel bracket some as well?
-
Senior Tech
100+ Posts
- Rep Power
- 0
You will probably need to replace 6le24385000. 13-tr-unit-1 item number 29. also the mylar that attaches to it, item 33. This has fixed all of our e011 errors.
-
Trusted Tech
50+ Posts
- Rep Power
- 28
Also check the transfer roller itself if it's the old style it will cause that, put it on a flat surface (like a table) and roll it you will notice some bending or the rubber start separating from its base
-
Thanks for the extra suggestions guys. If I have to go back on this machine or see this code again I will have more ideas to go on.
-
toner monkey
100+ Posts
- Rep Power
- 29
maybe increase trans roller ch bias
-
Senior Tech
100+ Posts
- Rep Power
- 34
Moving the transfer comb closer helped...doesnt jam as frequently but it still jams, all the 2nd transfer settings in 05 mode are withinh default range...the saga continues!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks