Dear firends,
I have face the problum of "please Wait" on display, even i have replaced the mother board pcb(logic pcb) still the problum not solved. expecting the suggestion to solve the problum.
S.Jinachandran
Dear firends,
I have face the problum of "please Wait" on display, even i have replaced the mother board pcb(logic pcb) still the problum not solved. expecting the suggestion to solve the problum.
S.Jinachandran
Does it constantly display 'wait' from booting up?
It didn't say that I couldn't do it in the manual.
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
try putting a new toner cartridge in
Do a 08-686 then turn the machine off using the power button after it completes, DO NOT PRESS THE 'CLEAR/STOP' BUTTON, just turn the machine off straight away after performing the 08-686. If that does not work do 08-669 and again turn the machine off after it completes, DO NOT PRESS THE 'CLEAR/STOP" BUTTON, just turn the machine off straight away after it completes.
Hold 1 3 * turn Machine one this clears all Mem and Machine works again
Reguards Harry
Tku for reply friends, now i removed the network (optional) box, now machine works fine, how to rectify the network printer board, is it anything related with 128 DDR ram, is it compitable with normal DDR RAM, both mother board and network printer card is new one, is it required and setup?
Last edited by sjinachandran; 07-01-2011 at 07:30 AM. Reason: adding aditional information
Hold down start stop and switch on machine with the too keys pressed!! After that there must be Ready in the display. Make 08 669 and the machine have to work again Other thing is the country code in 02 make shure to put right code in there
good Luck
Harry
tku for reply freinds, I tried with start and stop keys but no result, is it related with RAM used in this network unit, if so is it normal DDR ram or different one, and also how to get the country code?
You can try to change te CF-card in the net-controller (TDK brand)
In the past years I have changed few of them with good result.
Good luck
Bookmarks