Firmware e-Studio 35 trouble

[Aliadodelpunk]

Hi guys:
This is my 1st post in this community. I was trying to change the menu language in a e-Studio 35 copier, but something went wrong and now I have this error: Firmware version up mode, Recovery Mode: Target 4 failed. Press Start key to install new firmwares.

I would like to get this firmware software, but I cannot find it on the net.

I will be waiting for your answers, Thanx

[ToshiBoy]

The engine firmware on these is upgraded via jigs that plug straight into the board. you need the correct EEPROM on the jig, then just plug it in and it updates. However, I feel that you may have a different issue here. I have had this error before, but I can't remember what happened. I have a feeling it had something to do with the printer board, but maybe someone else knows...

[sergei]

perhaps you may try to clear the nvram flag.. if i remember correctly, go to "clear" + "3" mode, select 1. good luck

[Aliadodelpunk]

First of all thanks for your support.

The problem is that I can´t even get into the menu, because when I turn the copier on, inmediately the error appears.
I´m gonna try with another hard drive, and see what happens.

[ToshiBoy]

Before you change the HDD, disconnect the GL1010 and see if the copier comes up w/o it. That way you'll see if it is a copier or controller issue.