Need help
Helppppppppppppppppppppppppppppppp
meeeeeeeeeeeeeeeeeeeeeeeeeeeeee
I see it you have swapped the logic board and fuser from the broken machine to another and those parts worked on the other machine. Have you tried the power supply board?
When you get the code C440 is the fuser warm, hot or cold?
It didn't say that I couldn't do it in the manual.
im sorry. im not really familiar on this machine but have you try the to replace the IH board? if this machine have.
there is no glory without sacrifice
Give this a try. Sometimes the thermistor wire harness can get squashed right near where the fuser unit pin (locator) at the rear side of the fuser unit. Try a new set of thermistors and file some of the plastic frame away to give them a little more space.
It didn't say that I couldn't do it in the manual.
Bookmarks