 e-600 does not boot.
hi all,
e-600 doesn’t boot ,it shows the initial booting screen and stay at this point, the main menu is appear for a moment and then it returns to the same booting screen.
The diagnosis modes do not work, firmware mode also.
I’ve seen something similar before and it was from the HDD IDE harness this time I’ve replaced the cable, the HDD nothing changed.
I’ve also tried to replace the RAM but it was the same.
Any suggestions
Regards
Last edited by mhmsaqer; 10-02-2007 at 09:27 AM..
| 
Linear Mode
