Hi guys,
I have a toshiba 3560 and it gives me an error e01.
I literally have changed everything to the board , transfer ,sensors, fuser everything and it stills gives that same error
Any suggestions?
Hi guys,
I have a toshiba 3560 and it gives me an error e01.
I literally have changed everything to the board , transfer ,sensors, fuser everything and it stills gives that same error
Any suggestions?
thissensorisstuckinthelcc
lccopenatthe topblackouttoashutter
if not,removecover andpositiontheshutter
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
I would probably get a new machine rather than trying to repair this one. This is a really old model.
It didn't say that I couldn't do it in the manual.
nothing guys.
This machine will drive me crazy.
Any other opinions?
Are you getting a good power supple to the machine? Have you used a logic probe to check the sensor is working?
It didn't say that I couldn't do it in the manual.
E01 is the exit sensor. I would check that one out.
It didn't say that I couldn't do it in the manual.
Bookmarks