I did reinstall firmware 3 times and finished, but I not access into 08.
I changed hdd , can you help me.
Thanks
I did reinstall firmware 3 times and finished, but I not access into 08.
I changed hdd , can you help me.
Thanks
Good luck to you!
Did u mean that after finish update the firmware, u not able to perform 08-947?
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Did you go through all the items in the Firmware Assist mode such as clearing the NVRAM Flags?
Was the machine working prior to the firmware update?
Please don't ask me for firmware or service manuals as refusal often offends.
What is the machine original firmware version & current version?
may be the problem in the control panel . i saw this problem before in e35 and solved after replaced the panel
Use the start + 1 to check the display panel (i think that is the code). I am assuming the display will be working if you can press 4+9 for the firmware update but still worth a check. After a firmware update you need to go straight into the 08 codes. Code 947 then initialise (as didi mentioned). After the firmware update do you or can you access the 08 codes?
You could try repartitioning the hard drive before the firmware update.
What was the reason for the firmware update?
It didn't say that I couldn't do it in the manual.
try to formate hdd.. 08-690 and update firmware
Bookmarks