ERROR F10 ON E-STUDIO 35

[COPIERTEC ASSOCIATES]

Hi guys,i came across this error on the above machine and could not proceed.Any clues to this problem will be appreciated thanks in advance.

[vincent64]

[F10] HDD Initialization error
(1) Initialize the HDD. (mode (08)
n code"690" n 2)
(2) Check if the HDD is mounted.
(3) Check if the specified HDD is mounted.
(4) Check if the connector pins of the HDD are bent.
(5) Check if the power supply connector is disconnected.
(6) Check if the connector J111 on the SYS board is disconnected.
(7) Replace the HDD.
(8) Replace the SYS board.
(9) Replace the harness.

Kinda of a older model there, may also need firmware.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com