e-studio 35 developer setup

[micktill]

anyone know how to calibrate the toner sensor on the e-studio 35 after a dev change

[just a tech]

believe it's 05-200...after a couple of minutes values will start changing..set range is 235-245.. good luck

[micktill]

Much abliged for that info,thanks you say range is between 235-245 do you have to set it by pressing pressing print or pause or something?

[just a tech]

press "up" or "down" icon to adjust if not in range..press "set" when value is where ya want it..

[jawir]

Hi,

You also can use 6+Start+power On (PM Support mode) after on the control panel Display K letter, choose 1 to adjust the toner and developer material.

thanks

[micktill]

Handy to know I,ll try that
Thanks

[etsmultan]

do hv done tht?it is very simple!

[mckinley]

Hi,

You also can use 6+Start+power On (PM Support mode) after on the control panel Display K letter, choose 1 to adjust the toner and developer material.

thanks

an e-studio 35 doesn't have pm support mode , that's on the later machines such as e350.

[jawir]

Hi,

Yes I know, that PM support mode is only for eBridge generations. I preferred call this because it's easy say and it's same way in eS350/450.

regards