Toshiba E-Studio 255 Hard Drive Replacement

[CNG]

Hello All,

I require some assistance with replacing a hard drive on a E-studio 255. Firstly will a 320gb SATA I drive work in this machine or will that be too large? The machine was supplied without a hard drive so I think I will require the firmware to be installed again.

Can someone assist me with the procedures required to replace the hard drive, and also from where to source the firmware from (Justmanuals.com? open to suggestions) I am willing to pay to play (within reason). The other thing is that I am from Australia and am unsure if this affects what firmware I have to install.

Thank you in advance for your assistance.

[michaelc]

The machine should have a hard drive attached to the system board, and paul (just manuals should have the latest firmware) as most people on this site i do not give out firmware. They were originally shipped with 60GB hard drives but we have put 120gb plus in them with no problems.

Why are you replacing the hard drive?

[CNG]

Thank you michaelc for your reply.

The machine was purchased at auction and was ex-govt. I can only suspect that they removed the drive for security purposes?
I will get in touch with justmanuals and make the necessary enquiries about the firmware.

Are you able to assist with the procedure to install the firmware once I obtain it from justmanuals?

Finally I am after a GD1250 Fax Kit. Would anyone have any leads as to where I could find one?

Thank you for your help, its greatly appreciated.

[michaelc]

Justmanuals might give you the walk through procedure with the firmware, i am not sure though. If not post back here and i will help you.

[CNG]

Thank you for your offer of further assistance.

I have been researching into the GD-1250 fax kit and was wondering if there are any differences between the kits from differing regions (e.g NA/TW, EU/AU/AS, C, J). I can only find the GD-1250 kit from North America. Also is the GD-1250 universal in shape as it appears to fit many different e-studio models? Currently my machine has the USB + Network connections and a blanking plate for what would be the telephone connector. Any e-bridge 3 GD-1250 will fit?

Thank you for persisting with my questions.

[hoanphuc20033]

if you need it sent to your hdd firmware up okay
contact:

[Acme]

Check you P.M regarding the fax unit.

[MUMMIM]

Hi Nghiep!

Can you share to me that firmware (e255), i am needing it. send to me via email: thientinhvnn@gmail.com

thank you very much. i shall go to sg and invite you coffe

MUMMIM

if you need it sent to your hdd firmware up okay
contact:

[vinhsesco]

Hi Nghiep!

Can you share to me that firmware (e255), i am needing it. send to me via email: thientinhvnn@gmail.com

thank you very much. i shall go to sg and invite you coffe

MUMMIM

firmware huge amount can not be sent via email so you can bring up the copy usb. if not I can send original toshiba dvd for you.

[nhimlongxu]

You need to install software, fix the line copier toshiba contact me.