Toshiba e352 has c41 .How....fix..?

[anh_duongsb]

This morning ,I checked toshiba e352 which show me that error c41 .I check all and don't know how to fix this error .Plz help me solve this .Thanks

email: bloggerviet123@gmail.com

[toantam]

Dear Friend!
First you have to check therminstor and thermoswitch or you can try to reset error then try to change another fusing unit.
You can check DC power supply.
Good luck to you.

[Mad_Coachman]

This morning ,I checked toshiba e352 which show me that error c41 .I check all and don't know how to fix this error .Plz help me solve this .Thanks

email: bloggerviet123@gmail.com

08-400 start reset to 0 start

[anh_duongsb]

Dear Friend!
First you have to check therminstor and thermoswitch or you can try to reset error then try to change another fusing unit.
You can check DC power supply.
Good luck to you.

I checked them all and checked sys board but it is still the same .Thanks for your advice

[anh_duongsb]

08-400 start reset to 0 start

I did but still the same error c41 Thanks for your advice .Hopefully I can solve this problem as soon as possible .

[bvaldir]

After repairing the matter which caused the error [C410], perform the following:
(1) Turn ON the power while [0] and [8] are pressed simultaneously.
(2) Key in “400”, then press [START].
(3) Change the current status counter value “1” or “2” to “0”, then press [ENTER] or [INTERRUPT]
(to cancel [C410]).
(4) Turn the power OFF and then back ON. Make sure that the equipment enters the normal ready
state.

[anh_duongsb]

After repairing the matter which caused the error [C410], perform the following:
(1) Turn ON the power while [0] and [8] are pressed simultaneously.
(2) Key in “400”, then press [START].
(3) Change the current status counter value “1” or “2” to “0”, then press [ENTER] or [INTERRUPT]
(to cancel [C410]).
(4) Turn the power OFF and then back ON. Make sure that the equipment enters the normal ready
state.

I will try and let you know the result .Thanks so much .If any friends
who need toshiba firmware .Plz contact
me
thru bloggerviet123@gmail.com .I will give you for free .

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[anh_duongsb]

Dear all friends,
I changed power board and fuser to another copier .They work well .I can not find which is error for my copier .Plz help me .thanks

[vinhsesco]

Dear all friends,
I changed power board and fuser to another copier .They work well .I can not find which is error for my copier .Plz help me .thanks

hello you
if you do not reset at all. you can update the latest firmware version 356 will fix all errors. wish you success